thenewred

joined 1 year ago
[–] thenewred@lemmy.world 8 points 1 week ago

Radar from MASH

[–] thenewred@lemmy.world 8 points 1 month ago (6 children)

Why can't they use the excess energy to make the train go again?

[–] thenewred@lemmy.world 3 points 2 months ago (2 children)

What is this used for?

[–] thenewred@lemmy.world 17 points 2 months ago (6 children)

Is there a bad taxidermy community?

[–] thenewred@lemmy.world 24 points 2 months ago

They were asking for a ride. She speaks Ukrainian. I'm guessing she wasn't bothered by it.

[–] thenewred@lemmy.world 2 points 2 months ago

I might have crossed my wires, it was probably just a forum post I misread. I happened to have new ceramic burrs so I went ahead and installed them.

I got closer to a perfect pull this morning after adjusting the right lever! Unfortunately I'm out of that coffee now so the process restarts with the next bag.

[–] thenewred@lemmy.world 2 points 2 months ago* (last edited 2 months ago) (2 children)

New ceramic burrs.

I typically use light roast beans, apparently ceramic is better there.

Went through the hyperalignment procedure and got close but not perfect. Had to move on and get it back together at some point.

[–] thenewred@lemmy.world 2 points 2 months ago (1 children)

Works the same, just inline. And this grinder has two

 

Facepalm

[–] thenewred@lemmy.world 35 points 2 months ago (1 children)

Me writing my resume in third person

[–] thenewred@lemmy.world 22 points 2 months ago (1 children)

Is this comparing total number of visitors per year to inhabitants?

If so, it's a misleading graphic because visitors only stay for a week or two.

[–] thenewred@lemmy.world 2 points 3 months ago

A blessing! Free credit monitoring! All is well

[–] thenewred@lemmy.world 6 points 3 months ago (1 children)

Free solo*

But with a harness full of gear for extra weight reasons

And gloves because less grip == good?

 
 

I don't know why I even bother opening the settings app

0
Belt organizer (lemmy.world)
submitted 1 year ago* (last edited 1 year ago) by thenewred@lemmy.world to c/3dprinting@lemmy.world
 

Made entirely from 1x2 pine. Ripped into thirds for the shelf slats. Pocket holes. Glue. Brads and glue for the shelf slats.

 
view more: next ›