I've printed similar objects with a different colored PLA, but I ran out of it and switched to this.
Is it possible that this could be influencing the outcome?
I have tried reducing the printing speed by 50%, but this did not seem to have a significant impact.
[SOLUTION]
The problem was a loose screw. The offending part as well as the new result are pictured below. It's not perfect, which I guess is actually a part of the model this time, but it's good enough for my purposes and way better than what it was before.
I figured this out by twisting the Z-axis thingy manually all the way to the top to see if I could feel any issues. Towards the top, it would start to 'skip', where I would turn and pretty much nothing would happen. I assume this has to do with the lack of lube at the top because my prints rarely go that high. I checked to see if the screws were loose, and sure enough, the top one was. I tightened it up and now my printer is printing like the beast I remember!
![](https://lemmy.ca/pictrs/image/b4c1fd5a-5fa9-4cb2-92a9-dd4ff390ff29.jpeg)
![](https://lemmy.ca/pictrs/image/470b88ca-e178-4fbc-b8d2-3c5356895166.jpeg)
I think it's more fruitful to look at who benefits from the Ukrainian war.
Life for the average Ukrainian will not be radically different under Russian rule. Most of them will get up, go to work the same job they always have and funnel as much money as possible to those who already have it.
It just so happens that under Russian rule, Russian rulers will be making profit instead of Ukrainian rulers. The people actually fighting the wars never benefit and the ones who benefit never fight.