Unfortunately this is likely from an EU country, which usually carries a little more weight when it comes to cross-border law enforcement co-op.
ExcessShiv
Man I just wish all unsolicited ads would be banned, it would make the world a much better place. If I want promotional content or information about product portfolio from somewhere, I will request it directly.
If they are required by law to only sell to business with a valid licence, they also have to document that all their customers in that country have a valid business licence.
By selling it to someone private, even by proxy, would be illegal and they would be liable to lawsuits by doing so.
But what a PITA it would be if you have to use a seedbox for everything, and also expensive if you want/need to keep seeding torrents for extended periods of time so you're not just doing hit'n'runs. But yeah, piracy is pretty much always going to find a way to exist.
And seedboxes of course does nothing for the far more important general online privacy.
No you just need to disallow VPN providers to sell access without a business licence, that way the VPN provider can't legally give you access to their network unless you're a registered business, and it would simultaneously remove options for anonymous subscription like mullvad VPN.
Enforcing that you need a business licence to buy a VPN is easy and requires very little. They suddenly can't sell you a subscription if you can't provide the business licence.
The phrasing of the law would most likely allow use of VPN for commercial use but ban for private use, so it's unlikely to have a major impact on coorporate IT work in general.
The article also mentions this VPN ban in a context of VPN services being marketed specifically for piracy use as the scope rather than "legitimate" VPN services in general.
But yeah, these people can get bent...
Z offset like you mentioned is probably wrong, extrusion multiplier is probably wrong, extruder might be incorrectly calibrated, PA is definitely wrong. It really looks like it hasn't received any tuning at all and this was just done with OTB defaults.
With a result like yours I'd honestly just start from the top of Ellis guide and follow through to the end, that should help you fix this and get a significantly better print quality. There's likely a lot of things that are less than ideal, fixing only one or two won't be enough.
People accept different qualities I guess, if you're satisfied and it works then there's no reason to change things. I would say there's significantly more things that need tuning than just z offset.
Switzerland is not some magical safe haven outside the reach of agencies like Europol.