this post was submitted on 11 Jun 2023
1 points (100.0% liked)

Prusa Research

207 readers
6 users here now

A Community for discussing all things related to specifically Prusa Researchs 3D Printers like the MK3, MK4, Mini and XL

founded 1 year ago
MODERATORS
TheYang@lemmy.ml
1
Prusa Mini issues with very slow extrusion (lemmy.ml)
submitted 1 year ago by TheYang@lemmy.ml to c/prusa@lemmy.ml
0 comments fedilink hide all child comments
 

Hi there, I've been having a little trouble printing models with my MINI+, when there is very low extrusion between retractions. The Extruder grinds the filament through, and then the filament in the hotend burns until it gets stuck as well.

It usually only happens when I print extremely fine things like DnD (2") miniatures at .05mm layer height.
For now I've switched to .15mm layer height and have not had the issues since, but I wonder if there's something that could be done, except changing the Extruder/Hotend?

no comments (yet)
sorted by: hot top controversial new old
there doesn't seem to be anything here