Edit: The way I had it in the photos is correct. Thanks for helping me out, those who chimed in!
Original question:
I replaced the straight handlebars with risers on my mountain bike, and because of the slightly longer distances involved, I have to replace the brake and gear cables with slightly longer ones.
Unfortunately, I did not take a picture of the cable clamp for the front derailleur before I undid it. Now I'm clueless as to how to route the replacement cable - basically the same problem as this poster on RetroBike, except their derailleur is different from mine.
I have super old parts, so I've had a hard time finding documentation online. The best documentation I've found is the following:
- Parts List (1-page PDF)
- Service Instructions (1-page PDF)
In the service instructions, third column, "SIS adjustment" section, three-quarters of the way down, it says:
- Cut off any unnecessary cable, attach an end cup, and hook it onto the pin.
- Note: Pass the cable through as shown in the illustration.
What is absolutely throwing me for a loop is the illustration seems to show the cable running from the bottom upward, but... how? Can anyone help me figure out what I'm missing? I feel like a dumb dumb.
