3D Printing

4291 readers

1 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 3 years ago

MODERATORS

3dnudel@lemmy.ml

First glass bed failure with PETG (programming.dev)

submitted 10 months ago by CameronDev@programming.dev to c/3dprinting@lemmy.ml

1 comments fedilink hide all child comments

I have been printing with PETG on glass for a little while now, and have gone through almost an entire roll. Yesterday I had my first print stick so hard that it delaminated the glass :(. I stopped using hairspray as it made the prints not stick at all, and printing bare glass was just fine. But something about yesterdays print made the glass give up. Is this how PETG + Glass normally fails? Works perfectly for years, and then suddenly fails?

top 1 comments

sorted by: hot top controversial new old

[–] Contend6248@feddit.de 0 points 10 months ago

Just clean it with alcohol (IPA), dishwasher fluid or glasses cleaner spray