this post was submitted on 18 Jun 2023
0 points (NaN% liked)

Ask Electronics

3335 readers
11 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 1 year ago
MODERATORS
DavideAndrea@discuss.tchncs.de
linker3000@discuss.tchncs.de
0
How to properly size a serial bulb for protection when troubleshooting a circuit? (discuss.tchncs.de)
submitted 1 year ago by LemmyBr785@discuss.tchncs.de to c/askelectronics@discuss.tchncs.de
6 comments fedilink hide all child comments
 

Hello. I'm a hobbist on electronics repairs, and I did some repairs on stuff powered from the wall socket before, using a serial bulb to protect the circuit in case there's a short. Now I want to troubleshoot a board that works at 3V and very low current (like no more than 100mA). So, how can I properly size the bulb I need for this circuit before powering it? Or is there a better way to protect the circuit than a serial bulb? Thanks in advance.

you are viewing a single comment's thread
view the rest of the comments
[โ€“] rstein@discuss.tchncs.de 0 points 1 year ago (1 children)

And the bulb is a strange resistor, it has a really high current when starting up cold. This can fry everything behind it.

[โ€“] ConductiveInsulation@feddit.de 0 points 1 year ago

It has the high current because it's cold, it only needs a short time to heat up and light up and the majority of circuits can handle very short overcurrent really well because the connections need to heat up before they break. Using a lightbulb for current limiting works pretty well.