Electronics

2045 readers

67 users here now

Projects, pictures, industry discussions and news about electronic engineering & component-level electronic circuits.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: No circuit design or repair, tools or component questions.

5: No excessively promoting your own sites, social media, videos etc.

Ask questions in https://discuss.tchncs.de/c/askelectronics

founded 1 year ago

MODERATORS

DavideAndrea@discuss.tchncs.de

linker3000@discuss.tchncs.de

As a novice at soldering, I now have an opinion about single-sided vs. double-sided breadboards (lemmy.world)

submitted 10 hours ago by grue@lemmy.world to c/electronics@discuss.tchncs.de

12 comments fedilink hide all child comments

Me a few days ago, shopping on Amazon: "All the component and jumper wire leads are going to be on the bottom anyway; why shouldn't I get a pack of single-sided breadboards for $6.25 instead of double-sided ones for $10?"

Me today, after having lifted three pads off the damn board in 10 minutes: "Oh, that's why."

Get the double-sided breadboards; they're worth it.

you are viewing a single comment's thread
view the rest of the comments

[–] nerb@techhub.social 2 points 5 hours ago

@j4k3 @grue

I have a roll of very low temperature solder that has high bismuth content. It is not to solder with instead you use it lower the melting point of solder then wick it up . Was used at EMR Telemetry and when they were sold I was given a roll. Like a big roll of chip quik.

It is valuable to desolder things like ESP32s. The odds of lifting pads are slim with it too.