this post was submitted on 30 Aug 2024
65 points (100.0% liked)

3DPrinting

15763 readers
29 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS
65
Wood Temp Tower (lemmy.world)
submitted 3 months ago* (last edited 3 months ago) by MissJinx@lemmy.world to c/3dprinting@lemmy.world
 

This is the temp tower of my wood print experiment Cand even se much difference. It goes from 260 to 190. Below 225 gets really flimsy and above 240 melts. But even 230, the "best" one is really bad, and I'm not talking about retraction. Even the layers that melt are inconsistent.

Also it's not humidity since the filament was in a filament dryer for.16hours.

edit: The nozzle is 0.8

can someone think of anything else?

you are viewing a single comment's thread
view the rest of the comments
[–] MissJinx@lemmy.world 5 points 3 months ago

hum ill check but I used orca native temp tower and chrcked through the print? it didi chsnge. could it be a hardware problem?